WFLY Remote controller transmitter RC system WFT06II 2.4GHz 6ch


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab

WFLY Remote controller transmitter RC system WFT06II 2.4GHz 6ch for model helicopter aircraft plane hobby




Product Details

WFLY is a leading RC brand in China in RC hobby product with R&D and manufacturing. WFLY was the first one to release the first Chinese menu RC system, the first 2 radio system with 4096 resolution, the first 9ch RC system in China. Today, WFLY has developed a series of RC systems for entry to expert users and exported its products to countries worldwide with very good reputations.

Model name:  WFT06II
Use in:  Airplane, Helicopter, Car, Boat
Band:    2.400-2.483GHz
Output Power:  ≤ 100mW
Modulation:  2.4GHz DSSS spread Spectrum + Frequency Hopping
Memory: 8-model memory
Power:  3.7-6.0V ≤ 190mA

In the Box

1. WFT06II x1

2. WFR06S 2.4GHz receiver x1

3. Simulator cable x

4. WFLY Neck strap x1

5. English manual x1


1. Great choice for entry level users;
2. Dot-matrix + segment combo display;
3. Big LCD display brings easy menu operation;
4. Powered with native 2 technology directly derived from MCU, greatly improved speed and sensitivity;
5. Powered with DSSS + Hopping technology, High anti-interference performance. support up to 60 transmitters working together at the same time;
6. Low-supported design, lower battery consumption, a variety of battery available: 4s alkaline batteries,4s NIMH Nickel Metal Hydride ,1s lithium-ion battery, Voltage 3.7V-6V;
7. Digital Trim, Numeric display with E-tone alarm;
8. groups of model data storage;
9. 4 kinds of right-hand control to set programs, custom;
10. 5 Group curve design, each curve 5 point edit;
11. Variety of helicopters and airplane control functions supported;

  • 0 Units in Stock
  • Manufactured by: Wfly

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 20 February, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here