BGC Encoder Motor DM90-130T SlipRing 10kg Payload BGC controller

21 x BGC AS5600 Encoder Motor DM90-130T with slip ring & 1 Basecam Electronics BGC controller built in to the YAW motor DM90-130T, 10kg payload + i2cIMU
ii12c encoder connection & BGC connection between the three motors 3 axes and the connection with the IMU uses ii2c bus connection, mother board and BGC driver board module, IMU model. Connection Block uses JST standard standard 5 pin connector connection, easy to connect slip ring, wiring simple, easy assembly and maintain. The center of each board has a 12-bit encoder, the motor is ready for encoder firmware. Board voltage 2s-4s lithium battery.
Motor Dimensions 88x29.9mm
Weight 430g
Stator Dimension 80x10mm
Configuration 24N28P
copper Wire .30mm
Turns 130
Winding Type WYE
Max Normal Voltage 25V
Resistance Ri Qhm 17
idle current@10V 90mA
Max Stall current 3
Diameter of Hollow shaft 12.55mm
Stator mounting pitch size 58mm, 4xM4
Rotor mounting 30mm, 4xM4, 35mm, 4xM4
max weight 10kg
DM BGC Encoder MOTOR Documentation
DM 90-10 BGC motor specification
DM 90-15 BGC motor specification