25MM Multi-rotor the CNC aluminum boom clip & Bolt M2.5*37 20pc


$49.50

Add to Cart:
Min:  5

  • Description
  • Details
  • Reviews
  • Custom Tab
Features -25MM,22MM,20MM,16MM,15MM,14MM,12MM Multi-rotor the CNC aluminum Boom clip 20pcs full pipe clamp. Ask for the size you need. M2.5*37 and round head socket screw (25 pipe clamp special)/20 pcs Product Details -12mm aluminum tubes folder: Each 2g, four-axis 16 sets = 32g, six-axis 24 sets = 48g; -14mm aluminum tubes folder: Each set of 16 sets = 80g 5g, four-axis, six-axis 24 sets = 120g; -15mm aluminum tubes folder: Each 4.8g, four-axis 16 sets = 76.8g, six-axis 24 sets = 115.2g; -16mm aluminum tubes folder: Each 4.7g, four-axis 16 sets = 75g, six-axis 24 sets = 113g; -20mm aluminum tube clip: the each set 7g, four-axis 16 sets = 112g 24 sets of six-axis = 168g; -22mm aluminum tubes folder: Each 6.6g, four-axis 16 sets = 105g, six-axis 24 sets = 158g; -25mm aluminum clip: Each 7.7g, four-axis 16 sets = 122g 24 sets of six-axis = 185g; Four axes: 2X4 = 8 sets of the fixed fuselage center board, need 2x4 = 8 sets of fixed motor base, that is a set of four-axis rack requires a total of 16 sets of aluminum mounting base. Six-axis: the corresponding six-axis (2 +2) x6 = 24; If the assembly is a three-axis up and down six motors, but also need 12 sets of motor mounting plate to 6 (with three); similar four-axis assembly 8 motor, 16 sets of aluminum mounts, eight motor mounting plate.
 



 



 


 

  • 995 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 31 March, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here