HL W51-34 350KV Outrunner Brushless Disk Type Motor for Multi-ro



$78.00

Add to Cart:
Min:  6

  • Description
  • Details
  • Reviews
  • Custom Tab
Features:
- HL disk type motors specially designed for multi-rotor aircrafts.
- 3-point bearing design.
- Utilizing 0.2mm Silicon steel sheets.
- Dynamically balanced at factory, ensures maximum efficiency and low noise.
- Higher g/w ratio, very good choice for muti-rotor application.
- New prop adaptor design, you can fix the prop with prop adaptor, or mount the new series carbon fiber props directly to the motor without using prop adaptor.

Product Details:
Model: W51-34 350KV
Dimension: Φ 51.5x35mm (excluding prop adaptor)
Idel current: 0.6A at 7.4V
Net weight: 188g (excluding motor mount)
Cell number supported: 6S Lipo
-Max current: 30A
-Working current: <23A
-Max power: 700W
-Internal resistance: 0.055Ω
-Motor mount hole spacing: 19mm
-Prop adaptor output shaft diameter: 6mm
-Suggested prop size: 16 - 17inch
-Suggested ESC: 40A
-Prop direct mounting support: Yes
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 22 April, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here