Product Details
DJI Wookong Multi-Rotor stabilization controller is a complete flight system
for all multi-rotor platforms for commercial and industrial AP applications.
Unlike others, WooKong allows the use of regular ESC commonly used in RC
helicopter without any wiring modification; Heli mode setup providing a
seamless transition for current Ace One AP professionals. WK-M utilizes high
quality components precisely calibrated with temperature compensation in all
gyros and sensors, industry renounce flight algorithm in autopilot and UAV.
IMU damping system is rated for gas engine best in the class. Attitude mode
maintains precise altitude hold for indoor flight while GPS mode provides
superb position hold outdoor. External LED flight mode indicator light can
easily be observed by pilots under any condition. WK-M can be flown in one
single full auto (GPS-Atti) mode from take-off to landing; or in Atti mode
while manual mode has stabilization activated. The system is easy to install
with user friendly software allowing on-line firmware and software upgrade.
Features
- Fail-Safe Fail-Safe
- Fail Safe Hover
- Return to Home & Auto Landing
- Low voltage protection Low voltage protection
- Two-level low voltage protection
- Power Module Power Module
- Versatile power module for MC power supply
- voltage monitoring and CAN bus connections
- D-Bus supports S-BUS receiver system
General specifications |
Built-In
Functions: |
Autopilot |
|
Auto Hover Fail Safe |
Multi Rotor
Types: |
Quad-Rotor |
Hex-Rotor |
Octo-Rotor |
Supported ESC output: |
400Hz refresh frequencys |
Recommended Transmitter: |
PCM or 2.4GHz with minimum 5 channels and
Failsafe function available on all channels |
Recommended Power Supply: |
DC 4.8 ~ 12V |
Power
Consumption: |
MAX 5W |
(0.9A@5V,
0.7A@5.8V,0.5A@7.4V,0.4A@8V) |
Operating Temperature: |
-5°C to +60°C |
|
(You have to keep
the IMU warm if you want to use it under low temperature, could be -5°Cor
lower.) |
Flight
Performance (can be effect by mechanical performance) |
Hovering Accuracy: |
Vertical: |
± 0.5m |
|
Horizontal: |
± 2m |
Suitable Wind Condition: |
< 8m/s
(17.7mph) |
|
Max Rotate Angle: |
30° |
|
Vertical Speed: |
3m/s |
|
Packaging
&Shapes |
Total Weight: |
<= 150g |
|
Dimensions: |
Main Controller: |
61mm x 39.6mm x 15.8mm |
|
IMU: |
40mm x 31mm x 26mm |
|
GPS & Compass: |
50mm (diameter) x 9mm |
|
LED Indicator: |
25mm x 25mm x 7mm |
- 160 Units in Stock
- Manufactured by: DJI
This product was added to our catalog on Thursday 01 March, 2012.
Solar X-rays:
Geomagnetic Field: |
| |
Content
OFFTHEGRIDWATER.CA
Rc-toys Multi Rotor safty Tip
Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.