Home
Log In
OFFTHEGRIDWATER.CA
Aerial Photography CUSTOM UAV AR
Auto Pilot Controller
BRUSHLESS GIMBALS
Carbon fiber parts & fasteners
Cinematography & UAS Rentals
CineStar Replacement Parts
Electric air craft Motor & ESC
Multi Rotor Frame
Multi Rotor Parts
Multi Rotor RTF ARF KIT RC Craft
MultiCopter Propeller
RTF Ready to Play Kits
Transmitter & Receiver
Battery & Balance Charger
Brushless Motor
ESC
FPV Monitor
FPV Products & Parts
Mini Quad
Retractable Landing Gear
3D printer & Filament
Servos & Robots
Power Generator FUEL CELL
WHolesale
Multi Rotor DSLR Gimbal
Home
Auto Pilot Controller
Differential Airspeed Pito Tube Airspeed Sensor for Pixhawk
Differential Airspeed Pito Tube Airspeed Sensor for Pixhawk
Differential Airspeed Pito Tube Airspeed Sensor for Pixhawk
100 Units in Stock
Ask a Question
$48.00
Add to Cart:
Features
The modified airspeed tube is a digital differential pressure sensor,
I2C communication, suitable for PIXHAWK PX4. Unlike the analog
differential pressure sensor used by APM, APM is not universal.
Product Details
Check operation
* You can use APM Planner or other ground stations to read the airspeed count value.
Blow into the pito tube and observe the response. Zero and small oscillations
(2-3) are normal in still air. The airspeed changes with the square root of the
pressure, so the change at close to zero pressure difference is very small, and
a larger pressure change is required to produce the estimated speed change during
flight. If you see mostly 0, 1, 2, and occasionally bounce to 3 or 4, consider it
normal. You will not see such changes while flying.
* Sensor: the upper port is dynamic pressure, the lower port is static pressure
* ARSPD_BUS set as 0,use internal I2C
* ARSPD_SKIP_CAL set as 0, each time restart the flight controller, need to calibrate the
airspeed meter offset. Set to 1, automatically skip the airspeed gauge
offset calibration, using the last calibrated offset
* ARSPD_TUBE_ORDER set as 2,Automatic matching of the upper or lower tube is dynamic pressure
* ARSPD_TYPE set as 1, use I2C-MS4525D0
* In the ground station debugging interface, observe the change of the airspeed meter.
The general value jump is 1-3 in the normal range. Blow air to the airspeed meter.
If the airspeed value increases, the airspeed meter works normally.
PX4-DATUBE
Product 41/230
Previous
Return to the Product List
Next
This product was added to our catalog on Wednesday 03 November, 2021.
Home
Copyright © 2024
OFF THE GRID WATER
. Powered by
Zen Cart