Home
Log In
OFFTHEGRIDWATER.CA
Aerial Photography CUSTOM UAV AR
Auto Pilot Controller
BRUSHLESS GIMBALS
Carbon fiber parts & fasteners
Cinematography & UAS Rentals
CineStar Replacement Parts
Electric air craft Motor & ESC
Multi Rotor Frame
Multi Rotor Parts
Multi Rotor RTF ARF KIT RC Craft
MultiCopter Propeller
RTF Ready to Play Kits
Transmitter & Receiver
Battery & Balance Charger
Brushless Motor
ESC
FPV Monitor
FPV Products & Parts
Mini Quad
Retractable Landing Gear
3D printer & Filament
Servos & Robots
Power Generator FUEL CELL
WHolesale
Multi Rotor DSLR Gimbal
Home
Auto Pilot Controller
Mauch Sensor Hub HEX X2 HS Series Power Module For Pixhawk
Mauch Sensor Hub HEX X2 HS Series Power Module For Pixhawk
Mauch Sensor Hub HEX X2 HS Series Power Module For Pixhawk
100 Units in Stock
Ask a Question
$45.00
Add to Cart:
MAUCH 080 : Sensor Hub X2 / PIXHAWK
This sensor hub is to connect two current sensors in parallel.
The current of both sensors will be summarized and passed to the FC.
The voltage measurement of the Lipo packs will be collected from
both sensors and passed through the Hub to the FC.
The main purpose of this hub is to replace existing protection circuits
( like an idealdiode ) and to monitor, that both paralleled Lipo's supply
the same current to the system. Since we monitor the current of both
batteries, we will find out very early when a Lipo starts to fail ?
before it is too late. If the difference in current is bigger
than + / -10%, the Hub will issue a warning to the pilot via a
Power Led and / or buzzer ( fast flashing ) connected to the Alarm
I / O. If the difference in current is larger than + / -20%, the
Alarm output will be always ON to indicate the fault? the pilot
should immediately land and check the batteries.
Additionally, there is a reserve relay contact ( alarm ) for the user
to implement any desired function.
The I2C bus is for future integration.
Product Details
To set up a complete system you would need:
1x Sensor Hub X2
2x Current sensor board:
HS-050-LV or HV = 2x50A = 0-100A Tota
HS-100-LV or HV = 2x100A = 0-200A Total
HS-200-LV or HV = 2x200A = 0-400A Total
1x 2-6S BEC or 4-16S HYB-BEC
39mm x 31mm x 6mm / 7g without cables.
The board comes with 10cm connection cable
(DF-13-6p < - > DF-13-6p) to the FC and 2x 10cm
connection cables (DF-13-6p < - > DF-13-4P) to the sensor boards.
If you need a customized cables in different length,
then please order it separately.
MAUCH080
Product 136/230
Previous
Return to the Product List
Next
This product was added to our catalog on Monday 24 January, 2022.
Home
Copyright © 2024
OFF THE GRID WATER
. Powered by
Zen Cart