CUAV Pixhack V5 nano Small Flight Controller


$199.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- Compact but powerful V5 nano flight controller
- Support for hardware on open source platform PX4 and Autopilot
- Suitable for fixed-wing drones, helicopters, multi copters, FPVs, VTOL, Unmanned Boats, UAVs
- High Performance: Equipped with STM32F765 microprocessor, features 216MHz main
frequency, 2M flash and 512K SDRAM. There are four groups of isolation chips and a
MS5611 high-precision air gauge.
- Easy to install and dismantle with 2.6mm spacing between IO pins.
- Real-time Data Monitor: Five groups of built-in sensors enhance its safety and stable performance.
Product Details
Hardware parameter
-Processor:STM32F427
sensor
-Accelerometer:ICM-20608
-Gyro:ICM-20608
-Compass:HMC5983
-Barometer:MS5611
Interface
-Mavlink UART:2
-GPS UART:2
-DEBUG UART:1
-Remote control signal input protocol:PPM/SBUS/DSM/DSM2
-RSSI input:PWM or 3.3 analog voltage
-I2C:1
-CAN:1
-ADC input:6.6V X1
-PWM output:6 PWM IO
Support model:Copter/Plane/Helicopter/VTOL/unmanned vehicle/Rover, etc.
Working environment and physical parameters
-Operating Voltage:4.5 ~ 5.5 V
-USB Input voltage:5.0 V +- 0.25v
-Servo input voltage:4.8~5.4V
-Operating temperature:-20 ~ 60°c
Size & Weight
-Size:57*34*17mm
-Weight:40g

CUAV Pixhack V5 nano Small Flight Controller For Ardupilot PX4 FPV Drone
CUAV Pixhack V5 nano Small Flight Controller For Ardupilot PX4 FPV Drone
CUAV Pixhack V5 nano Small Flight Controller For Ardupilot PX4 FPV Drone
CUAV Pixhack V5 nano Small Flight Controller For Ardupilot PX4 FPV Drone
CUAV Pixhack V5 nano Small Flight Controller For Ardupilot PX4 FPV Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 05 May, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here