CUAV X7+ PRO NEO V2 GPS for PX4 ArduPilot Flight Controller


$999.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
STM32H743 processor
Aerospace grade ADI16470
accelerometer & gyroscope
RM3100 Industrial grade compass
X7+ PRO autopilot uses STM32H743 series processors CPU,
Cortex-M7 core (with double precision Floating-Point Unit).
It makes operating frequency increase to 480Mhz, 2MB Flash,1MB RAM,
Meet the higher computing needs of flight controllers Compared
with the STM32F7 product line, the dynamic power consumption
efficiency is doubled.
Product Details
X7+ PRO Flight Controller
Processor:STM32H743
Frequency:480MHz
Flash:2MB
RAM:1MB
Acce & Gyro:ADIS16470;ICM-42688-P;ICM-20689
Compass:RM3100
Barometer:MS5611x2
LxWxH:77x45.5x39mm
Weight:105g
Firmware support:Ardupilot 4.10 / PX4 V1.12.3 or above version
Model support:Multi-Copter / Plane / Helicopter / VTOL /
unmanned vehicle / Rover , etc
NEO V2 GPS
Chip Type
- GPS Location:UBLOX M8N
- RGB Status light:NCP5623C
- Compass:IST8310
- Buzzer:Passive buzzer
- Buzzer:Physical buttons
Positioning Performance
- Accuracy:3D Fix
- Update rate:10Hz(Max)
- Acquisition:Cold Start 26S | Host Start 1.5S |
Aided Start 2S | Reacquisition 1S
- Receiver type:72 Channels GPS/QZSS L1 C/A, GLONASS L10F
BeiDou B1I, Galileo E1B/C SBAS L1 C/A: WAAS, EGNOS, MSAS, GAGAN
- Sensitivity:Tracking & Navigation -167dBm | Cold Start -148dBm |
Hot Start -156dBm | Reacquisition -160dBm
- Functional
1. Advanced jamming
2. Fast search satellite speed Security and integrity protection
3. Receiving up to three GNSS at the same time
Working Conditions
- Input voltage:5V
- Temperature:-10 - 70°C
CUAV-X7+PRO
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
CUAV X7+ PRO Flight Controller Open Source Autopilot With NEO V2 GPS for PX4 ArduPilot FPV RC Drone Quadcopter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 32/196

 Prev 
 All 
 Next 

This product was added to our catalog on Wednesday 10 August, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here