DJI Wookong WK-M GPS Multi-Rotor Stabilization Autopilot System

$1,171.00  $899.90
Save: 23% off

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
DJI Wookong Multi-Rotor stabilization controller is a complete flight system for all multi-rotor platforms for commercial and industrial AP applications. Unlike others, WooKong allows the use of regular ESC commonly used in RC helicopter without any wiring modification; Heli mode setup providing a seamless transition for current Ace One AP professionals. WK-M utilizes high quality components precisely calibrated with temperature compensation in all gyros and sensors, industry renounce flight algorithm in autopilot and UAV. IMU damping system is rated for gas engine best in the class.
Attitude mode maintains precise altitude hold for indoor flight while GPS mode provides superb position ...
Product Details
Multi Rotor Types: Quad-Rotor / Hex-Rotor / Octo-Rotor
Supported ESC output: 400Hz refresh frequencys
Recommended Transmitter: PCM or 2.4GHz with minimum 5 channels and Failsafe function available on all channels
Recommended Power Supply: DC 4.8 ~ 12V
Power Consumption: MAX 5W (0.9A@5V, 0.7A@5.8V,0.5A@7.4V,0.4A@8V)
Operating Temperature: -5°C to +60°C (You have to keep the IMU warm if you want to use it under low temperature, could be -5°Cor lower.)
Flight Performance (can be effect by mechanical performance) Hovering Accuracy:
Vertical: ± 0.5m
Horizontal: ± 2m
Suitable Wind Condition: < 8m/s (17.7mph)
Max Rotate Angle: 30°
Vertical Speed: 3m/s
Packaging &Shapes
Main Controller: 61mm x 39.6mm x 15.8mm
IMU: 40mm x 31mm x 26mm
GPS & Compass: 50mm (diameter) x 9mm
LED Indicator: 25mm x 25mm x 7mm
Total Weight: <= 150g
Built In Functions
Fail-safe Hover
Gimbal Stabilization
Voltage monitor
Go Home & Auto Landing
WooKong-M View Data Link
Hardware Interface: USB2.0
Radio Frequency: 900 MHz / 2.4 GHz
Transmit Power: 1000mW / 130mW
Data-Throughput: 11,520 bps
Communication(Open air): ≤3km (2.4GHz 2dbi antenna) ≤10km (900MHz 2dbi antenna)
  • 0 Units in Stock
  • Manufactured by: DJI

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 20 February, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here