F4 Raceflight STM3 2F405 Flight Controller without PPM


$27.00  $27.00
Save: 0% off

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
F4 Racing STM32F4 CPU Flight Control Compatible with LibrePilot/RaceFlight/OpenPilot for Multirotor
Product Details
Item name: F4 Racing flight control Weight: 5g
1) 36mm x 36mm (standard 30.5mm between mounting holes)
2) Support raceflight and betaflight firmware, default is BF.
3) Use MPU6000 accelerometers and gyroscopes
4) Gyro and MCU have 3.3V independent power supply
5) Support LED strip and blackbox
6)Has outputs for up to 6 motors (ESCs)
7)Three available hardware UART ports
8)Built in inverter for SBUS input
9)STM32F405 32-bit processor at 168MHz, 1Mb flash, 192kb ram
10)Micro USB connectivity using STM Virtual Communications Port
11)M25P16 16 Mbit, serial Flash memory, 75 MHz SPI bus interface
12)1x7pin JST-SH socket (SUBS,SERIAL,RX,TX,5V,GND)
13)6X3pin though-holes for pin headers for ESC
14)No BEC
F4 Racing STM32F4 CPU Flight Control
F4 Racing STM32F4 CPU Flight Control
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 53/196

 Prev 
 All 
 Next 

This product was added to our catalog on Monday 26 September, 2016.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here