Orange Cube+ HEX Flight Controller Ardupilot Pixhawk Cubepilot

Features
The Cube Orange+ Standard Set features a high-performance H7 processor
and the 1090MHz ADS-B receiver from uAvionix. The Cube Orange+ has
upgraded IMUs and the STM32H757 MCU. The autopilot can be set up to
automatically avoid aircraft that are detected in an exclusion zone
set by the pilot. Previously known as Pixhawk 2.1.
Please note that:
At present, due to the relatively new chip,
PX4 firmware and old apm firmware are not supported temporarily.
Firmware above v4.2.3 of apm can be used.
Product Details
Sensors: Accelerometer, Gyroscope, Compass, Barometric Pressure Sensor
Power input voltage/rated input current: 4.1-5.7 V / 2.5 A
Power rated output/input power: 14 W
USB port input voltage/rated input current: 4-5.7 V / 250 mA
Servo rail input voltage: 3.3 V / 5 V
Not waterproof. External waterproof protection is needed
Operation Temperature: -10 °C / 55 °C
Cube Orange+ Housing Material: CNC Aluminum Alloy
ADSB Carrier Board Housing Material: ABS Molding
Orange Cube+ Flight Controller x 1
HX4-06222
HEX Orange Cube+ Flight Controller Standard Set Ardupilot Pixhawk Cubepilot For Quadcopter Drones
HEX Orange Cube+ Flight Controller Standard Set Ardupilot Pixhawk Cubepilot For Quadcopter Drones

HEX Orange Cube+ Flight Controller Standard Set Ardupilot Pixhawk Cubepilot For Quadcopter Drones
HEX Orange Cube+ Flight Controller Standard Set Ardupilot Pixhawk Cubepilot For Quadcopter Drones
  • 100 Units in Stock



$460.00

Add to Cart:

This product was added to our catalog on Saturday 03 December, 2022.

Copyright © 2023 OFF THE GRID WATER. Powered by Zen Cart