PX4 Micro Flight Controller W/ M8N High Precision GPS PIXFALCON


$210.00

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
Features - The PIXFALCON Micro flight control using same main processor and sensors, functions and hardware compatibility also same as Pixhawk flight control. - Buzzer and safety switch are integrated in the new version, wiring is neater. The safety switch can be installed to outer shell when your multicopter has cover for main frame. Product Details PIXFALCON Micro Flight Controller W/ M8N High Precision GPS
Processor
. 32bit STM32F427 Cortex M4 core with FPU
. 168 MHz
. 256 KB RAM
. 2 MB Flash
. 32 bit STM32F103 failsafe co-processor
Sensor
. ST Micro L3GD20H 16 bit gyroscope
. ST Micro LSM303D 14 bit accelerometer / magnetometer
. Invensense MPU 6000 3-axis accelerometer/gyroscope
. MEAS MS5611 barometer
Interfaces
. 1x UART (serial ports)
. Spektrum DSM / DSM2 / DSM-X Satellite compatible input
. Futaba S.BUS compatible input and output
. PPM sum signal input
. I2C
. Internal microUSB port
Power System and Protection
. Ideal power multiplexer with automatic current Limit
. All peripheral outputs over-current protected, all inputs ESD protected
Item Packing
1x PIXFALCON autopilot main board
1 x GPS
1 x current sensor
1 x USB cable
1 x wire set

  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 28 August, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here