Tarot CC3D openpilot open source stabilization Flight control


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
CC3D openpilot through the machine is suitable for open-source flight control,
etc. through the machine 200/250/300 TAROT mini, standard exclusive shock-sided stickers,
standard silicone cable 3 (8P one, 4P two) Product Details
Case Size: 40mm * 40mm * 14mm
Bare board size: 36mm * 36mm
Bare board NW: 7.3g
Shelled Weight: 15.2g
Tarot CC3D openpilot Flight control board x 1
Tarot CC3D openpilot open source stabilization Flight control board TL300D
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Tuesday 28 September, 2021.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here