3 Axis Brushless GIMBAL Steadicam Pro System RTF


$1,120.85

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
3 Axis Brushless GIMBAL system & Handheld Steadicam 4mm 3k carbon fiber

In stock now

Free Shipping by DHL/Fedex/UPS/EMS/Russia express
Gimbal is RTF, compatible with CineStar copter parts
comes with:
Carbon Fiber Camera Gimbal frame kit x 1
Iflight 6208H-150T Brushless Gimbal brushless motor x 3
3 axis AlexMos BGC Gimbal Controller(32bit) x 1
3s 11.1v 2200mAh battery x 1
3s battery charger x 1
Aluminum controller board box x 1
power cable with switch X1
all the controller cables ready to use plug and play Technical adjustment required
sony NEX, BMPCC,BMCC, SONY 7N, RX100, GH4, Cannon 5D mark II,
3 Axis Brushless GIMBAL Steadicam Pro System RTF
3 Axis Brushless GIMBAL Steadicam Pro System RTF
3 Axis Brushless GIMBAL Steadicam Pro System RTF
3 Axis Brushless GIMBAL Steadicam Pro System RTF

Manual for 3 Axis direct drive gimbal
Manual in PDF format
  • 50 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 02 December, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here