BEC UBEC 20A 2-3S LiPo Rccskj High Current Linear Regulator


$44.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- The external switch can turn on/off the UBEC easily.
- It has two status LED, which lights up when the BEC works normally.
- 4.8-8.4V arbitrary voltage output, applicable for all kinds of receivers/gyros/servos, etc.
- Linear buck chip is used to provide pure and sufficient working power for the receiver and servos etc.
- Exquisite aluminum case is helpful for heat dissipation & EMI (Electromagnetic Interference) reduction.
- 2 cables are connected in parallel at the output end of the BEC, allow larger current to flow into the receiver.
Product Details
Input voltage: 6V - 13V (2-3s lipo)
Output voltage: 4.8-9.7v (freely adjusted to adapt to various high and low voltage servo)
Output current: 0-20a (Max: 30a)
Overall dimension: 50mmx38mmx13mm
Item Packing
Rccskj High Current Linear Regulator x 1
PH-031
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
Rccskj High Current Linear Regulator BEC UBEC 20A 2-3S LiPo With Switch For 3D Aircraft Turbojet 8106#
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 20/134

 Prev 
 All 
 Next 

This product was added to our catalog on Saturday 14 May, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here