D-Shot ESC 4-IN-1 BLHELI S iPeaka EFM30A MUILTSHOT


$49.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
DShot is a new communication protocol between flight controller (FC) and ESC, substitute to Oneshot and Multishot. DShot stands for Digital Shot.
Advantage of DShot
Compared to Oneshot and Multishot, we are informed that DShot is better because:
*No More ESC Calibration Required (no oscillator drift)
*More Accurate ESC Signal, and more robust against electrical noise
*Higher Resolution of 2048 Steps, compared to others of 1000 steps
*Faster Than Oneshot
*Safer, every signal has cyclic redundancy check
Support s D-shot .
BB21 MCU, 48Mhz Runs BLHELI_S J_H_xx firmware
Supports 3-6S lipo input
4PWM input
Current and Voltage output
NO BEC
Supports oneshot / Multishot / Dshot PWM
Only 36x36mm, mount holes 30.5x30.5mm
Supports damped light
NO External capacitors needed
Package included:
- 1 x iPeaka EFM30A BLHeli_S D-shot 4-in-1 ESC
To learn more about D-shot ESC,please visit the write :WHAT IS DSHOT ESC PROTOCOL https://oscarliang.com/dshot/
Attention:
Please do not connect external decive like video transmitter, camera etc. to the power soldering point.
(Adding BEC module to power the external divice is recommend.)
D-Shot ESC 4-IN-1 BLHELI S iPeaka EFM30A MUILTSHOT
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 24 January, 2017.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here