DYS 20A 2-4S Speed Controller Simonk Firmware for Multicopter


$16.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
l Drive tube and high-power Mos, and Mos tube plus a separate heat sink, Extreme low output resistance of the PCB(printed circuit board),super current endurance.
2 The power input uses extreme low output resistance greatly enhance the power stability, and has the protective effect on the battery.
3 Safety electrical function: when the power is turned on, regardless of the throttle stick in any position does not start the motor immediately, to avoid personal injury.
4 Separately voltage regulator IC for microprocessor. providing good anti-jamming capability.
5 Supported motor speed (Maximum): 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles).
6 Using Simon K’s a dedicated multi-copter program tgy_debug, and the master chip with high stability crystal oscillator, making the motor control to more precise.
Product Details
DYS 20A 2-4S Speed Controller (Simonk Firmware) for Multicopter | V2
1 Running current:20A(Output: Continuous 20A, Burst 25A up to 10 Secs.)
2 Input Voltage: DC 6-16.8V(2-4S Lixx)
3 BEC: 5V 2amp.
4 Size: 46mm (L) * 26mm (W) * 11mm (H).
5 Weight: 22g
6 With SimonK updated firmware for multicopter
Item Packing
-DYS 20A 2-4S Speed Controller X 1
DYS 20A 2-4S Speed Controller Simonk Firmware for Multicopter
DYS 20A 2-4S Speed Controller Simonk Firmware for Multicopter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 22 April, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here