Hobbywing 2 IN 1 Professional Program Box


$20.58

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
This Advanced Program Box is used to set the programmable parameters of brushless ESC, it has a 16*2 characters LCD (Liquid Crystal Display) to get a friendly user interface, so you can set the programmable parameters very easily. It is pocket-sized, so you can bring it to the racing or flying field conveniently.
This program card is suitable for the following ESCs:
1. XERUN Series Car ESC (Version 2.0)
2. EZRUN Series Car ESC (Version 2.0)
3. PLATINUM Series Helicopter/Aircraft ESC
1 Working Mode
1.1 Working as an individual device to set the ESC, the value of each parameter is displayed on its own LCD.
1.2 Working as an USB adapter to link the ESC with a PC, and the user can update the firmware of the ESC or set the ESC by the special application software on PC. Product Details
2.1 Size: 90mm (L) * 51mm (W) * 17mm (H)
2.2 Weight: 84g.
2.3 Input Voltage: 4.8-6V (If the ESC hasn’t a built-in BEC, you must use an additional battery pack to supply the program box)
3 Programmable Items
A) The programmable items for the CAR ESC are:
3.1 Running Mode
3.2 Drag Brake Force
3.3 Low Voltage Cut-Off Threshold
3.4 Start Mode
3.5 Maximum Brake Force
3.6 Maximum Reverse Force
3.7 Initial Brake Force
3.8 Throttle Neutral Range
3.9 Timing
3.10 Over-Heat Protection
3.11 Motor Rotation
3.12 Lipo Cells
B) The programmable items for the AIRCRAFT AND HELICOPTER ESC are:
3.1 Brake Setting
3.2 Battery Type
3.3 Low Voltage Protection Mode (Cutoff Mode)
3.4 Low Voltage Protection Threshold (Cutoff Threshold)
3.5 Start Mode
3.6 Timing
3.7 Governor Mode
3.8 Motor Type
3.9 PWM Frequency
3.10 Built-In BEC Output
3.11 Motor Load
3.12 Lipo Cells
  • 0 Units in Stock
  • Manufactured by: Hobbywing

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 12 May, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here