Hobbywing Pentium-60A ESC 2-6 cells lithium battery



$46.84

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features -Safety Arming Feature: Regardless the Throttle Stick position, the motor will not spin after battery connected. This will prevent any injury happened. -Throttle Calibration: Throttle range can be configured to provide best throttling linearity, fully compatible with all market available transmitters. - Programmable Items: ●Brake Settings:brake enabled / brake disabled, default is brake disabled ●Battery Type:Li-xx(Li-ion or Li-poly) / Ni-xx(NiMh or Nicd),default is Li-xx. ●Low Voltage Protection Mode(Cutoff Mode) :power reducing / power cutoff, default is power reducing. ●Low Voltage Protection Threshold(Cutoff Threshold) :low / medium / high, default is medium cutoff voltage. -For Li-xx battery,number of battery cells are judged automatically,low / medium / high cutoff voltage for each cell are: 2.6V/2.85V/3.1V. For example: 3 Cells Li-Poly, when medium cutoff -For Ni-xx battery, low / medium / high cutoff voltages are 0%(ie. never cut off )/45%/60% of the startup voltage. For example: a 10 cells NiMH battery pack, fully charged voltage is 1.44*10=14.4V, when medium cutoff voltage is set, the cutoff voltage is : 14.4*45%=6.5V. ●Startup mode: normal / soft / super-soft, default is normal startup. ●Timing: low / medium / high, default is medium timing. In normal cases, low timing can be used for most motors. But for high efficiency, we recommend the Low timing for 2 poles motor and Medium timing for 6 poles and above. For higher speed, High timing could be used. -Full Protection Features: Low-voltage cutoff protection / over-heat protection / throttle signal lost protection. Product Details
-Output: Continues 60A, Burst 80A up to 10 Secs.
-Input Voltage: 5.6V --- 26.0V ( Lithium : 2 – 6s or NiMH/NiCd 5 -18 Cells) -BEC (Battery Elimination Circuit) Output:
●Pentium-60A: (linear mode BEC):3A
●Pentium-60A-OPTO: None. Pentium-60A-OPTO is often used with an UBEC
-Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BLM. (BLM: BrushLess Motor)
-Size:
●Pentium-60A:28mm*56mm*15mm(width*length*height)
●Pentium-60A-OPTO:28mm*56mm*14mm(width*length*height)
-Weight:
●Pentium-60A:45g
●Pentium-60A-OPTO:44g
- Packaging include:
3 sets of gold plated motor connectors and heat-shrink tubings (Remark: motor connectors and heat-shrink tubings need to be purchased additionally) Advangages -Military Standard Capacitor with extremely low resistance used on voltage input section, this will increase the ability of prevention of unwanted RF Noise/ Interference during flying. -Seperate PCB for control circuit and MOSFET circuit: adiabatic air gap between control circuit PCB and MOSFET circuit PCB reduces the heat exchange form MOSFET to control circuit, so the ESC works more reliable.
-Extreme low resistance, super current endurance.
-Microprocessor and BEC use separate voltage regulator IC, with good anti-jamming capability.
-Compatible with Hobbywing's Program Card .
-Own complete intellectual property rights.
  • 25 Units in Stock
  • Manufactured by: Hobbywing

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 28 December, 2012.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here