Hobbywing Xrotor 10A Speed Controller for Multicopter


$12.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1.1 rotor is special program, the throttle response speed, surpass all kinds of open source software;
1.2 firmware for disk motor optimization, have very good motor compatibility;
1.3 highly intelligent, adaptive ability, keeping only into the Angle set (Gao Jinjiao/into Angle), is extremely easy to use;
1.4 the throttle signal lines for twisted pair, effectively reduce the signal within the copper wire transmission of crosstalk, make flying is more stable;
1.5 up to support the refresh rate of up to 621 hz throttle signal, compatible with all kinds of flight control (note: more than 500 hz throttle signals are non standard throttle);
1.6 use special MOSFET driver chip, performance and stability than using discrete component of driving circuit;
1.7 low impedance MOSFET, strong resistance to flow ability.
Hobbywing Xrotor 10A Speed Controller for Multicopter
  • 1000 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 15 May, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here