T-Motor F45A 3-6S BLHeli_32 32Bit 4-in-1 ESC


$64.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
This ESC is T-Motor's 4-in-1 version of their popular F45A ESC. This 4-in-1 ESC packs 45A into an industrialized PCB layout made with premium features such as a 32bit main control chip, BLHeli_32 firmware, and 6s support.
The F45A 4-in-1 comes with a heatsink attached to keep heat away from sensitive electronics.
Another small bonus is the 4 x motor wire PCBs that come with this ESC. These go on your quad arms and help prevent damage to your motor wires from prop strikes or other damage. A neat little touch to include them.
Features
32bit Main Control Chip: Compared with traditional MCU of 8 bit, 32bit stm32f051 main control chip enjoys the advantage of fast computing speed and multiple functions. Fast Response Speed: Prompt and accurate response on throttle signal receiving for the euphoria from zero lag operation.
Original BLHeli_32 Firmware: Original BLHeli_32 firmware with powerful performance and diverse functions capable of ESC parameter setting and firmware upgrading makes the ESC far more reliable and efficient.
Specifications
Model No: F45A 6S 4IN1 32bit
Con. Current: 4*45A
Peak Current (10S): 4*53A
Lipo: 3-6S
Weight: 18g
Size: 49 x 40 x 6.9mm
Includes
1 x T-Motor F45A 3-6S 4-in-1 ESC
4 x Damping Rubbers
4 x Motor Wire PCB
2 x 8pin wiring harness (1x 70mm, 1x 30mm)
2 x 35v 470uf Capacitor
T-Motor F45A 3-6S BLHeli_32 32Bit 4-in-1 ESC
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 09 December, 2018.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here