Xrotor 10A Speed Controller for Multicopter Hobbywing



$8.20

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1.1 rotor is special program, the throttle response speed, surpass all kinds of open source software;
1.2 firmware for disk motor optimization, have very good motor compatibility;
1.3 highly intelligent, adaptive ability, keeping only into the Angle set (Gao Jinjiao/into Angle), is extremely easy to use;
1.4 the throttle signal lines for twisted pair, effectively reduce the signal within the copper wire transmission of crosstalk, make flying is more stable;
1.5 up to support the refresh rate of up to 621 hz throttle signal, compatible with all kinds of flight control (note: more than 500 hz throttle signals are non standard throttle);
1.6 use special MOSFET driver chip, performance and stability than using discrete component of driving circuit;
1.7 low impedance MOSFET, strong resistance to flow ability.
Model

Con. 
Current

Peak Current
(10s)

BECLiPoProgrammable ItemWeightSize

Typical Applications*
(For reference)

XRotor-10A10A15ANo2-3S

Timing
(High/Intermediate)

6.5g36.5 x 16.4 x 4.1250 Class Quadcopter
XRotor-20A20A30ANo3-4STiming
(High/Intermediate)
14g52.4 x 21.5 x 7

330/450 Class
Quadcopter

XRotor-40A40A60ANo2-6STiming
(High/Intermediate)
26g68 x 25 x 8.7

550/650 Class
Quadcopter

XRotor-50A50A70ANo2-6S

Timing
(High/Intermediate)

LED (On/Off)

LED Color (Red/Green)

Motor Rotation
(CW/CCW)

46g48 x 30 x 15.5

Over 650 Class
Quadcopter

  • 100 Units in Stock
  • Manufactured by: Hobbywing

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 14 May, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here