CINESTAR 3 Axis Brushless GIMBAL system Steadicam & LANDING GEAR


Please Choose:


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
CINESTAR 3 Axis Brushless GIMBAL system & Handheld  Steadicam 4mm 3k carbon fiber, for Hover fly, Cinestar, Droid works, DJI S800 adaper avaleble, Electronics may be shipped separately, Free shipping by DHL/Fedex registered mail available for latin America

In stock now if out of stock 30 day before Item is  Shipped

3 Axis Brushless GIMBAL system & Handheld Steadicam 4mm 3k carbon fiber

In stock now

Free Shipping by DHL/Fedex/UPS/EMS/Russia express
comes with:
Carbon Fiber Camera Gimbal frame kit x 1
for Hover fly, Cinestar, Droid works, DJI S800, DJI S1000, carbon core, adapter available separately
pelican stile carrying case x 1
Hand held gimbal stand x 1
Iflight 6208H-150T Brushless Gimbal brushless motor x 4 OR
Iflight GBM 5208H-120T Brushless Gimbal motor x 4
Optional Landing gear motor Iflight 8108-90T Brushless Gimbal brushless motor x 1
3 axis NEW Encoder AlexMos BGC Gimbal Controller(32bit)Base Cam Electronics Advanced x 1
4s 14.1v 2200mAh battery x 1
3s battery charger x 1
3 x AS500 or 6500 encoder, encoder license sold apart
Aluminum controller board box x 1
power cable with switch X1
all the controller cables ready to use plug and play Technical adjustment required
This is for the deluxe CineStar kit with 2 Yaw motors Iflight GBM 5208H-120T for copter landing gear and hand held Iflight 8108-90T for Yaw motor cages. kit is lighter than previous model because of smaller copter YAW motor, aluminum parts, good for up to 10lb pay load and good go Panasonic GH3, Canon 5D Mark3, NIKON D700, & Black Magic Cinema Camera.

CINESTAR 3 Axis Brushless GIMBAL system Steadicam & LANDING GEAR
Manual for 3 Axis direct drive gimbal
Manual in PDF format
  • 96 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Tuesday 04 June, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here