ST800 six-rotor aircraft Kit Folding design


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
ST800 six-rotor aircraft Kit Folding design

Product Details
1.The machine mainly consists of carbon fiber composite materials, matching joints of aluminum alloy to ensure the strength of body as well as to effectively reduce the weight. 2.The connections of landing gear are formed with 14mm carbon fiber tube,which is composed with metal and carbon fiber,to be assembled and repaired easily. 3.Supporting tubes are made from 12mm carbon fiber tube, the span between tubes is 155mm, it accommodates with mainstream camera gimbal in the market. 4.There are two extended boards in front and rear of the fuselage,it is convebient for the installation of GPS, receivers and other equipments. 5.Battery frame is fixed by metal connectors,the canter of gravity of the aircraft can be adjusted by slidding the battery frame back and forth. 6.The plastic cover can effectively protect the electronic equipment,and reduce both thecost and the risk of flight 7.The fuselage plate is made of 1.8 mm carbon fiber composite plate, guaranteeing the strength, and meanwhile effectively reducing the payload of the aircraft,and increasing the flight time. 8.Extra strength motor mount is made of high strength carbon fiber plate, greatly strengthening the safety of the aircraft. 9.The center distance between the two supporting tubes is 155mm.please match the right gimbal according to the size. when adjusting the gravity of the aircraft, loosen the set screws, slid the battery component to the appropriate location, tighten the screws and the battery.
Product Details:
-Empty Frame Weight:1090g
-Payload Capability:1500~2500g
-Flight Time:>10 minutes
-Motor:ST4708 350KV (not include)
-We recommend you use propeller with 15 inch。
  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 03 December, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here