SuperbeeF4 Lite SPI ELRS RX EX0802 KV19000 1S 65mm HD Whoop


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
Introducing Mobula6 HDZero, the very first 65mm HD brushless whoop in
the World, weights less than 23.5 grams only!
We have been working on innovations of Brushless Whoop for a few years.
Just like many of you, we are particularly eager to have a 65mm FPV whoop
carrying HD VTX. Teaming with HDZero, Runcam, Nick Burns, Mr Shutterbug,
Ryan Quellet and many other enthusiasts, here the dream comes true finally!
Product Details
Brand Name: Happymodel
Model: Mobula6 HDZERO
Frame wheelbase: 65mm
Weight: 23.5 gram without battery
Size: 80mm*80mm*50mm
Receiver option:
Compatible with 1S Lipo battery or Lihv battery
Battery Plug: PH2.0
Flight controller SuperbeeF4 Lite FRSKY
• SPI ELRS version Firmware target: CrazybeeF4SX1280
• MCU:STM32F411CEU6 (100MHz, 512K FLASH)
• Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)
• Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in Betaflight OSD(SPI Control)
• Built-in SPI Frsky/ExpressLRS receiver
• Built-in 5V 1A BEC
• Built-in voltage detection
Onboard 4in1 ESC
• MCU upgraded to EFM8BB21
• Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
• Currents: 5A continuous peak 6A (5 seconds)
• Support BLHeliSuite programmable
• Factory firmware: O_H_5_REV16_8.HEX
• Default protocol: DSHOT150/DSHOT300/DSHOT600
Onboard SPI ExpressLRS 2.4GHz Receiver
• Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
• RF Frequency: 2.4GHz
• Antenna plug: IPEX
• Telemetry output Power: <12dBm
• Receiver protocol: SPI ExpressLRS
• Could bind with ELRS V2.0 firmware TX module
• Mode: EX0802 19000KV
• Configu-ration:9N12P
• Stator Diamter:8mm
• Stator Length:2mm
• Shaft Diameter:F1mm
• Motor Dimension(Dia.*Len):F10.5mm*14.9mm
• Weight(g):1.7g
• No.of Cells(Lipo):1S only
Propeller Gemfan 1219 Bi-blades
• Weight:0.19g
• Material: PC
• Pitch:1 inch
• Props Dia:30mm
• Center Hole Dia:1mm
HDZero Nano Lite Camera
• 14x16x11 mm
• 1.5gram
• 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMos sensor
• Excellent low light performance
• Fov: 4:3: D:130° H:108° v:84°
16:9:D:122° H:108° V:65°
HDZero Whoop Lite VTX
• 1S Input
• 25mW/200mW RF Output-SmartAudio Support
• 25.5x25.5 M2 Soft Mounting- Antenna Retention
• Removable Shielding Box- 32.5x32.5mm(29x29mm inner)
• 4.5grams/4mm Thickness (without shielding)
HappyModel Mobula6 HDZero SuperbeeF4 Lite Built-in SPI ELRS RX EX0802 KV19000 1S 65mm HD FPV Brushless Whoop Drone
HappyModel Mobula6 HDZero SuperbeeF4 Lite Built-in SPI ELRS RX EX0802 KV19000 1S 65mm HD FPV Brushless Whoop Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Tuesday 28 June, 2022.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here