ZF450 KIT include 2-Axis Brushless Gimbal For Gopro 3


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
-Wheelbase 450, convenient to carry, 2 axial brushless gimbal integration design integration, low cost, convenient assembly.
Abandoned the traditional tall frame design, gimbal hanging in the nose to FPV flight directly
Product Details
-ZF450 KIT include 2-Axis Brushless Gimbal For Gopro 3
Suggested setting (not included):
Motor: BM-LD221298M or similar
Propeller: CF1045
Lipo battery: 4000 to 5000mAh 3S
This kit come with two gimbal motors And ZF450 KIT plus no soldering required
4 x EMAX MT Series MT2216 810KV Outrunner Brushless Motor for Multi-copter
1 x HOBBYWING Skywalker Quattro 25A x 4 4-in-1 Speed Control for Quadcopters
1 x DJI NAZA LITE Flight Stabilization Controller ( Multicopter NO GPS )
1 x V3 Gimbal brushless controller board + sensor board package by Martinez

  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Wednesday 11 December, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here