ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module


$60.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The ES24TX Pro Micro ExpressLRS TX module is a upgrade version of ES24TX module.$60
Max output up to 1000mw, reserved Cooling Fan and RGB LED module. This Micro TX
module support most of the OpenTX radio transmitter that with Micro JR bay.
And this time the ES24TX Pro module comes completely assembled before out of factory.
Product Details
Regulatory Domain: ISM2400
MCU:ESP32(main),ESP8285(aux, as esp back pack)
RF chip: SX1281IMLTRT
JR standard 5pin socket
Frequency Range: 2400 MHz to 2500 MHz
Maximum receive refresh rate: 500Hz
Minimum receiver refresh rate: 25Hz
RF Output Power: >30dBm
Power supply voltage: 5v~10v
Weight: 51gram(without antenna）
Dimension: 70mm*49mm*32.5mm
Antenna gain: 4.18dBi
Firmware target: HappyModel_ES24TX_Pro_Series_2400_TX
ES24TX-PRO
Happy Model ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module with Cooling Fan RGB LED Module for RC Airplane FPV Drone
HappyModel ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module with Cooling Fan RGB LED Module for RC Airplane FPV Drone
HappyModel ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module with Cooling Fan RGB LED Module for RC Airplane FPV Drone
HappyModel ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module with Cooling Fan RGB LED Module for RC Airplane FPV Drone
HappyModel ES24TX Pro 1000mW 2.4G Express LRS ELRS Micro TX Module with Cooling Fan RGB LED Module for RC Airplane FPV Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 20/167

 Prev 
 All 
 Next 

This product was added to our catalog on Monday 25 April, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here