FrSky 2.4GHz ACCESS ARCHER SR10 PRO Receiver


$77.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The Archer SR10 PRO are gyro-stabilized receivers with a built-in 3-axis gyroscope and
3-axis accelerometer, they have 10 high-precision PWM channel outputs and features
multiple flight modes and configuration methods. They support full-range signal strength
with dual detachable antennas it guarantees optimal antenna-reception and maximum range.
In addition to all this, the SR10 PRO can also be used as a redundancy receiver along with
any other FrSky ACCESS capable receiver equipped with an SBUS port. The SR10 PRO 10-channel
receivers’ noticeable features are its Anti-vibration performance and dual-battery ports for redundancy.
All of the Archer receivers are hyper-matched with the ACCESS protocol.
They not only feature wireless firmware upgrades and increased range and telemetry
performance, the SR10 Pro now supports more functions like configurable telemetry power,
S.Port/F.Port/F.Port 2.0 switching and FLR output. Additional valuable features are
under development to unlock the true potential of the ACCESS protocol.
- ACCESS protocol with Over The Air (OTA)
- Built-in 3-axis gyroscope and 3-axis accelerometer sensor
- Multiple flight modes and configuration methods (LUA & Freelink)
- Supports signal redundancy (SBUS In)
- Supports power redundancy (Dual battery ports)
- Full control range with telemetry
- S.Port / F.Port / F.Port 2.0
- Anti-interference in spark-ignition
- Anti-Vibration
- External battery / device voltage detection
Product Details
Dimension: 48.5*33*17mm (L*W*H)
Weight: 23g
16/24 Configurable SBUS Channels
10 high-precision PWM Channels
Operating Voltage Range: 3.5 -10V
Operating Current: ＜60mA@5V
Control Range: Full range* with telemetry
(*Full Range: ＞2km, range may vary based on local conditions.)
Voltage Measurement Range via AIN2 (External device): 0-36V
Compatibility: All FrSky ACCESS transmitters
SR10-PRO
FrSky 2.4GHz ACCESS ARCHER SR10 PRO Receiver Built-in 3-axis Gyroscope 3-axis Accelerometer for RC Quadcopter RC Drone
FrSky 2.4GHz ACCESS ARCHER SR10 PRO Receiver Built-in 3-axis Gyroscope 3-axis Accelerometer for RC Quadcopter RC Drone
FrSky 2.4GHz ACCESS ARCHER SR10 PRO Receiver Built-in 3-axis Gyroscope 3-axis Accelerometer for RC Quadcopter RC Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 50/167

 Prev 
 All 
 Next 

This product was added to our catalog on Sunday 23 January, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here