Clouds Fly ARF EPO Kit


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab

Clouds Fly ARF EPO Kit & battery





The Clouds FLy ( new EPO foam glider,super suit for the beginer) 

•  New EPO foam , more tough and very smooth in surface 

•  Brushless power system, supply plenty power 

•  Small in size, easy to transport 

•  Fly very steady ,very easy to assemble and control(10-15 minutes

This radio has CCPM function, can be used for both helicopters and airplanes, but emphasizes on helicopters..

-Ordinary 6 channel airplane functions.

-Ordinary helicopter mix function

-CCPM helicopter mix function.

-Flying backward for helicopter.

-Travel adjust ( TRVLADJ)

-The stick inching function for heli PLT when at full throttle.

-The stick inching function for heli PLT when at full close throttle.

-The locked and unlocked function for helicopter PLT. PZT.

-Helicopter throttle hold.

-At helicopter state, if the flying backward switch has already been turned on, when you trun on the transmitter it will buzz and stop the task.

-Channel 1,2,3,4,6 reverse switch.

-Sound-and-light hint notification for low power: when the battery voltage is below 8.8V, the power indicator light 1S/1S glitters and buzzes. And when it is below 8.3V, the power indicator light 0.5S/1S glitters and buzzes at the same time

Product Details

Wing span: 1.28 M/50.3 inches

wing area: 0.23 sq. m. 

weight:  450 g

length:  0.86 M/33.8 inches

Motor:  Out runner brushless motor: 2208N 2200 KV

ESC:  20A Brushless ESC with switching BEC 

Servos:  3-4 9g servos 

Battery:  1500-1800mAh (3 cells)

Package: 6pcs/Carton(117*50*70cm,19kg)

Kits version:  only with motor

RTF version: with motor,ESC,and servos 

Transmitter type: FT06-C 6 channel (Heli/Acro)

Receiver: FRP06 6 channel receiver ( using UM-5 mini size RX crystal )

Band: 40Mhz/35Mhz/72Mhz

Model: Model 1 ( throttle on right hand) and Model 2 ( throttle on left hand ) optional ( Please specify the model when place your order )






  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Saturday 21 July, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here