Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Camera


$300.99

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
attery:18650*2, 2200mAh, 3.7V
Usage Time In Theory: 10 Hours (When camera is balanced well with gimbal)
Charging Time: ≥5 hours, recommending using smart charger for charging the battery, 5V/1A input.
Controllable Range: Tilt: 360°(Unlimited) Roll: 360°(Unlimited) Panning: 360°(Unlimited) Adjusting Motor Strength: Automatic identification algorithm to detect weights of different cameras and produce right motor strength to match with them , so that the gimbal will

automatically be in the best performance without adjusting the motor strength.
Weight: 1111.4g (not inclusive of battery, camera, lens and so forth)
Cameras Supported:
Canon 5D Mark III (with standard lens)
SONY A7RII / ILCE-7R / ILCE-5100
Panasonic LUMIX GH4/GH5,
SONY NEX-5N/NEX-7
and other cameras of N-series,and other cameras with similar dimensions.
Payload : 250--3000g (Including the accessories of batteries, lens and ect.)
Item Packing
Single handheld version
1 x Ti 1 x USB Cable
4 x 18650 Battery
1 x Smart Charger
1 x Thumbscrew
1 x Screw for Camera Support Frame
1 x Camera Support Frame
1 x Adjusting Clamping Plate
1 x General Tripod
1 x 1/4inch Screw
1 x Cold Shoe
Detailed Images
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
Ti 3-Axis Gimbal Handheld Stabilizer for small DSLR Cameras
  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 108/114

 Prev 
 All 
 Next 

This product was added to our catalog on Tuesday 22 August, 2017.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here