2 Axis Gimbal Stabilization Module GSM110 X-CAM


$71.52

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
X-CAM 2 Axis Gimbal Stabilization Module GSM110 Features:
-X-CAM 2 Axis Gimbal Stabilization Module GSM110 Product Details:
-X-CAM 2 Axis Gimbal Stabilization Module GSM110 Specification
Input Voltage:5 - 6V
Volume:45 x 35 x 10 mm
There are 4 versions of this series product available

1. 2 Axis Stabilization: GSM110, GSM210

2. 3 Axis Stabilization: GSM120, GSM220
And this one is version GSM110. How to use the Remote Controller for Servo Reverse Setup

1.Connect to channel CH5 on the Printed Circuit Board (PCB)

2.Push this channel to the highest position on your Remote Controller

3.There will be 3 BEEPs followed by the Red LED flashing, Return the Remote Controller Lever to the middle position to enter the Servo Reverse Setup mode

4.Move the Remote Controller Lever to the Highest or lowest position to set the Servo Reverse after hearing the BEEPs.(One BEEP means Channel 1 (TILT) , Two BEEP means Channel 2 (ROLL), Three BEEP means Channel 3 (PAN) ), If you do not want to change the setup, Just move the Remote Controller Lever to the Middel position.

5.When you hear 4 BEEPs, the setup has been save

  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 10/277

 Prev 
 All 
 Next 

This product was added to our catalog on Monday 22 April, 2013.

Customers who bought this product also purchased...

17x 5.5 Carbon Propeller Set (one CW, one CCW)

17x 5.5 Carbon Propeller Set (one CW, one CCW)


Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here