DJI Phantom 2 Vision Battery Spare 5.2A 5200mAH LiPo 11.1V



$169.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. Easy to Plug In and Take Out - New connectors make plugging in the battery and pulling it out super easy. No need to pull or connect any cables.
2. Precise Battery Level Indication - On the original Phantom, battery levels used to be estimated by measuring voltage. As the motor spins, voltage drops making these estimates inaccurate. The DJI Intelligent Flight Battery monitors the total amount of energy consumed, so it can offer a precise battery level indication.
3. Super Long Flight Time - The Phantom 2 Vision flew for 28 minutes covering around 10 miles. This has never been achieved before.
4. Integrated Battery Level Checker - 4 bright LED's built into the battery module display the battery level, can be viewed and monitored during close flying.
5. Easy to Recharge - All balancing and protection circuits are integrated inside the battery, making charging as simple as connecting the battery to the charger. Battery indicator lights will keep you updated on charge progress.
6. Safer than Ever - Short protection and large current protection are all integrated into the battery.
7. Increased Battery Life - In the past, if a battery is dropped it may stop working. The DJI Intelligent Flight Battery’s frame protects the cells, keeping batteries safe. On the original Phantom if the battery isn’t disconnected, it will drain and become unusable. The DJI Intelligent Flight Battery has low voltage protection. Once it reaches a certain limit, it will turn itself off
Product Details
-JI Phantom 2 Vision Battery Spare Replacement LiPo 11.1V 5200mAH


  • 100 Units in Stock
  • Manufactured by: DJI

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 03 February, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here