AXi 2820/18, special, long lead wire, short shaft


$133.77

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab

AXi 2820/18 brushless motor with 700mm long wires and shortened shaft, with radial propeller driver. This new addition to the AXi 2820 series provides additional torque over the existing 2820 series motors for use in multi-rotor applications and is especially suitable for the SkyJib Lite and similar frames using 14" propellers.
The included radial propeller driver has a 6mm shaft.
Made in Czech Republic.

Technical Details For AXi 2820/18 Short-Shaft
No. of cells (LiPo) 4-5s
RPM/V 670 Kv
Max. Efficiency 85%
No load current 1.0A
Maximum Load 25.0A
Internal Resistance 0.110Ω
Diameter 35.00mm (1.38")
Length 48.00mm (1.89")
Shaft Diameter 5.00mm (0.20")
Max. Efficiency Current 8-20A
Glow Equivalent -
Weight 146.0g (5.1oz.)
  • 50 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 28 December, 2012.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here