BGC Encoder Motor DM40-15 with slip ring & 1 BGC controller

3 x BGC Encoder Motor DM40-15 with slip ring & 1 Basecam Electronics BGC controller built in to the YAW motor DM90-15, 10kg payload
This is for a set of 3 DM90-15 BGC GIMBAL Motor 1 IMU 1 BGC controller
ii12c encoder connection & BGC connection between the three motors 3 axes and the connection with the IMU uses ii2c bus connection, mother board and BGC driver board module, IMU model. Connection Block uses JST standard standard 5 pin connector connection, easy to connect slip ring, wiring simple, easy assembly and maintain. The center of each board has a 12-bit encoder, the motor is ready for encoder firmware. Board voltage 2s-4s lithium battery.
RMD motor datasheet
RMD-S servo motor instruction V1.5
0.8kg payload
Motor Dimensions 88x29.9mm
Weight 55g
Stator Dimension 39.6x22.6mm
Configuration 24N28P
copper Wire .30mm
Turns 130
Winding Type WYE
Max Normal Voltage 10.5-21V
Max Stall current 3
Diameter of Hollow shaft 8.1mm
max weight .8kg
BGC Encoder Motor DOC DM 40-10 motor
BGC Encoder Motor DOC DM 40-15 motor
BGC Encoder Motor DOC DM 40-5 motor
DM BGC Encoder MOTOR Documentation