8 axis Octocopter KIT 1050mm 3K Carbon Fiber Heavy lifter ARF


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab

1050mm 3K Carbon Large Scale Octocopter Kit for Commercial Aeria




Product Details

Lang Of After Fold:784mm
Height Of After Fold:100mm
All Weight:1200g
This octocopter is designed for commercial aerial photography application: -3K carbon structure, strong yet light in weight. -Dual shock absorbing design for Gimbal system, effectively eliminate "rolling shutter" effect. -Shock absorbing design for flight control system. -Optimized for DJI WOOKONG flight control and ZENMUSE Gimbal (not included) -Two battery mounting positions. -Heavy duty landing skid During our real testing, it can work 15 minutes under below setting: Fly weight is around 9-9.5kg, using 6S 20000mAh Lipo battery, cut-off voltage is set to 3.7V/cell.



- 1050mm Large Scale Octocopter Kit for Commercial Aerial Photography
-Material: 3K carbon and aluminum fittings.
-Rotor spacing: 1050mm
-Height: 50cm
-Rotor number: 8
-Fly weight: 8 to 12Kg (depending on motors used)
-Central plate size: 28cm, thickness 2mm
-Arm tube diameter: 22mm
-Recommended setting (not included):
-8-10Kg fly weight HL4230 390KV, fly time about 15 minutes with 20Ah 6S Lipo
-10-12Kg fly weight HL4830 390KV, fly time about 10 minutes with 20A 6S Lipo
-Flight control and gimbal: DJI WOOKONG + ZENMUSE Gimbal
-Camera: Canon 5D2 etc.
-Speed controller: 30A 6S
-Prop size: 15x5.5inch
-Battery: 5000mAh 6S x4

  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Thursday 18 April, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here