DYS D800-6 Hexacopter Multicopter


$799.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Propeller Size: up to 16 inch, 16 inch recommended
Center Plate: 240mm x 240mm
Recommended Cameras: Canon 5D / Canon C100 / Sony FS700 / Panasonic GH3
Payload: 8+ lbs. depending on motor setup
Flight Controller: MikroKopter FlightCTRL 2.5 or DJI A2
ESC: MikroKopter ESC's or similar 40A+ ESC (Freefly or Castle Creations)
Battery: 6s LiPO with 8000+mAh
Suitable Camera Gimbals:
- Freefly Systems: MoVi MR, 2 and 3 axis Cinestar gimbal
- Photo Higher: Pro Mount 200, Halo 2000
- DJI Zenmuse Z15
Items Included:
15 X Cross Member
8 X Hub Connector
6 X Motor Mount Assembly
1 X Rail Mount Assembly
4 X Velcro Battery Strap
3 X Inner Arms
6 X Outer Arms
1 X TOP Center Plate
1 X Bottom Center Plate
2 X Battery Tray
1 X GPS Plate
3 X Boom Clamp Set
Note:
Landing Gear, Motors and Electronics are not included in this frame kit.
Please contact us if you have any questions.
32bit AlexMos Brushless Gimbal Controller by iflight RC
  • 50 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 17 June, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here