4-in-1 Speed Control Quad HOBBYWING Skywalker Quattro 20A x 4


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab

-4 speed controllers in1board, only 1 pair of battery wire is needed.
-Powerful switch mode built-in BEC (the BEC voltage outputs from the S3 connector).
-Multiple protection features: Low voltage cut-off protection / over-heat protection / throttle signal loss protection.
-The throttle range of each ESC can be calibrated to be suitable for different multi-rotor flying control systems transmitters.
-Maximum speed: 210000 RPM (2 poles motor), 70000 RPM (6 poles motor), 35000 RPM (12 poles motor).

Product Details:
-HOBBYWING Throttle Hub for Quadcopter ESCs THRHUB
-Model: skywalker Quattro 20A*4-UBEC
-Burst Current(>10s):25A*4
-BEC MODE: Switch model
-BEC Output:5V@3A
-BEC Output Capability:2S Lipo(5 servos)/3S LIPO(5 SERVOS) /4S Lipo (4 servos)
-Battery Cell:LIPO(2-4S)/NIMH(5-12 cells)


  • 0 Units in Stock
  • Manufactured by: SKYWALKER

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Wednesday 03 April, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here