10x Frsky 2.4GHz RadioTelemetry DJT+D8R 2 Way Communicati


Add to Cart:
Min:  10 Units:  10

  • Description
  • Details
  • Reviews
  • Custom Tab



-The Two-way Radio System developed by FrSky provides an additional return link that would be used for monitoring the Rx’s voltage, temperature, location, speed and so on.

-Compatible with the following transmitters:
Futaba: 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z, 10C, FN series, T10C, FC-18, FC-28.
Hitec: Optic 6, Eclipse 7, Prism 7.

-Advanced Continuous Channel Shifting Technology ACCST SYSTEM achieves high reliable link in interference rich environments.
-Easy to bind and instant link-up.
-Excellent reboot times.
-All channels failsafe.
-Quick response.
-Very smooth servo movement.
-Alarm on events of receiver (low battery voltages, poor reception, etc.)
-Error-free link, by using 48bits CRC algorithm.
-Low power consumption.
-True two-antenna diversity.
-Firmware upgradeable.

-4. Function of Two Way communication
-Two way communication between receiver and transmitter
-Receiver is able to accept 2 analog inputs, which can be used to monitor battery voltage, temperature sensor, etc., and transfer them to transmitter. Users can set the Alarm Level of these analog voltages, when exceed or below these levers, sound alarm is issued.
-Receiver is able to accept serial data streams from simple 3-wire RS232 port, such information as GPS, altitude, and user developed data can be transferred to Tx without error, and sent at the RS232 port on the Tx.


Product Details

-Operating Voltage Range: 6.0V-13.0V Operating Current: 50mA Output Power: 60mW Resolution: 11bit (3072)-Model: D8R
Weight: 16.2g Dimension: 54*27*17mm Operating Voltage Range: 4.0V-7.2V Operating Current: 100mA Specified Range: 1.5km (Ground Range) Resolution: 11bit (3072) Latency: 22ms Number of Channels: 8CH Analog voltage: 0~3.3V


Item Packing

-Transmitter module (Model: DJT)x 1
-Receiver module(Model: D8R)x 1




  • 160 Units in Stock
  • Manufactured by: FlySky

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Thursday 01 March, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here