10x DJI Naza Flight Stabilization Controller Multicopter DJI-NAZ


Add to Cart:
Min:  10 Units:  10

  • Description
  • Details
  • Reviews
  • Custom Tab



All-in-One Design integrates inner damping, controller, gyroscope, accelerometer and barometer, which simplifies installation and saves space.
Advanced mix guidance algorithm and control algorithm, inherits outstanding flight stability of DJI products, provides excellent maneuverability, gives hobbyists wonderful flight experience
Two-level low voltage protection. low voltage LED alarm, and automatic landing.
D-Bus supports S-BUS receiver system
The gimbal stabilization module is compatible with almost all 2-axis gimbal systems. The system will adjust the gimbal and camera according to the attitude of the helicopter after setting the parameters the first time.
Upgradeable and extendibleEasy firmware upgrade, extendible port for future use is available.

Product Details

Built-In Functions  Autopilot 
Auto Level Fail-safe 
Low Voltage Protection 
S-Bus Receiver Support 
2-axle Gimbal Support
Supported Multi-rotor  Quad-rotor I, X;
Hex-rotor I, V.
Supported ESC output  400Hz refresh frequency. 
Recommended Transmitter  PCM or 2.4GHz with minimum 4 channels.
Assistant Software System Requirement

Item Packing

DJI NAZA Multirotor Stabilization Controller by DJI Innovations for Quadcopters x 1




  • 100 Units in Stock
  • Manufactured by: DJI

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Thursday 01 March, 2012.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here